Modeling of the permeate flux during microfiltration of BSA-adsorbed microspheres in a stirred cell

Sung Wook Choi, Jeong-Yeol Yoon, Seungjoo Haam, Joon Ki Jung, Jung Hyun Kim, Woo Sik Kim

Research output: Contribution to journalArticle

22 Citations (Scopus)

Abstract

A study on the variation of the permeate flux was performed in a stirred cell charged with microspheres, to investigate the effects of the stirrer speeds (300, 400, and 600 rpm) and the BSA concentration (0.1, 0.2, 0.4, and 0.8 g/L) under constant pressure. The permeate flux increased over time before the saturation point, but it began to decrease after that point. An increase of the BSA concentration and the stirrer speed resulted in the rapid increase of the permeate flux. This is contrary to the observation of the conventional filtration experiments using a stirred cell. A resistance-in-series model was employed for the modeling of the permeate flux. The cake resistance (R(c), induced by the concentration polarization of microspheres) and the fouling resistance (R(f), induced by the adsorption of BSA inside the membrane pore) must be considered simultaneously for the modeling. These modeling results were in good agreement with the experimental data. These can be applied to the special system considering both R(c) and R(f) as well as the general filtration systems using a stirred cell. (C) 2000 Academic Press.

Original languageEnglish (US)
Pages (from-to)270-278
Number of pages9
JournalJournal of Colloid and Interface Science
Volume228
Issue number2
DOIs
StatePublished - Aug 15 2000
Externally publishedYes

Fingerprint

Microfiltration
Microspheres
Fluxes
cells
fouling
Fouling
Polarization
membranes
Membranes
porosity
saturation
Adsorption
adsorption
polarization
Experiments

Keywords

  • Flux modeling
  • Microspheres
  • Resistance-in-series model
  • Stirred cell

ASJC Scopus subject areas

  • Colloid and Surface Chemistry
  • Physical and Theoretical Chemistry
  • Surfaces and Interfaces

Cite this

Modeling of the permeate flux during microfiltration of BSA-adsorbed microspheres in a stirred cell. / Choi, Sung Wook; Yoon, Jeong-Yeol; Haam, Seungjoo; Jung, Joon Ki; Kim, Jung Hyun; Kim, Woo Sik.

In: Journal of Colloid and Interface Science, Vol. 228, No. 2, 15.08.2000, p. 270-278.

Research output: Contribution to journalArticle

Choi, Sung Wook ; Yoon, Jeong-Yeol ; Haam, Seungjoo ; Jung, Joon Ki ; Kim, Jung Hyun ; Kim, Woo Sik. / Modeling of the permeate flux during microfiltration of BSA-adsorbed microspheres in a stirred cell. In: Journal of Colloid and Interface Science. 2000 ; Vol. 228, No. 2. pp. 270-278.
@article{37e1de040452493c8036bc4297b22056,
title = "Modeling of the permeate flux during microfiltration of BSA-adsorbed microspheres in a stirred cell",
abstract = "A study on the variation of the permeate flux was performed in a stirred cell charged with microspheres, to investigate the effects of the stirrer speeds (300, 400, and 600 rpm) and the BSA concentration (0.1, 0.2, 0.4, and 0.8 g/L) under constant pressure. The permeate flux increased over time before the saturation point, but it began to decrease after that point. An increase of the BSA concentration and the stirrer speed resulted in the rapid increase of the permeate flux. This is contrary to the observation of the conventional filtration experiments using a stirred cell. A resistance-in-series model was employed for the modeling of the permeate flux. The cake resistance (R(c), induced by the concentration polarization of microspheres) and the fouling resistance (R(f), induced by the adsorption of BSA inside the membrane pore) must be considered simultaneously for the modeling. These modeling results were in good agreement with the experimental data. These can be applied to the special system considering both R(c) and R(f) as well as the general filtration systems using a stirred cell. (C) 2000 Academic Press.",
keywords = "Flux modeling, Microspheres, Resistance-in-series model, Stirred cell",
author = "Choi, {Sung Wook} and Jeong-Yeol Yoon and Seungjoo Haam and Jung, {Joon Ki} and Kim, {Jung Hyun} and Kim, {Woo Sik}",
year = "2000",
month = "8",
day = "15",
doi = "10.1006/jcis.2000.6940",
language = "English (US)",
volume = "228",
pages = "270--278",
journal = "Journal of Colloid and Interface Science",
issn = "0021-9797",
publisher = "Academic Press Inc.",
number = "2",

}

TY - JOUR

T1 - Modeling of the permeate flux during microfiltration of BSA-adsorbed microspheres in a stirred cell

AU - Choi, Sung Wook

AU - Yoon, Jeong-Yeol

AU - Haam, Seungjoo

AU - Jung, Joon Ki

AU - Kim, Jung Hyun

AU - Kim, Woo Sik

PY - 2000/8/15

Y1 - 2000/8/15

N2 - A study on the variation of the permeate flux was performed in a stirred cell charged with microspheres, to investigate the effects of the stirrer speeds (300, 400, and 600 rpm) and the BSA concentration (0.1, 0.2, 0.4, and 0.8 g/L) under constant pressure. The permeate flux increased over time before the saturation point, but it began to decrease after that point. An increase of the BSA concentration and the stirrer speed resulted in the rapid increase of the permeate flux. This is contrary to the observation of the conventional filtration experiments using a stirred cell. A resistance-in-series model was employed for the modeling of the permeate flux. The cake resistance (R(c), induced by the concentration polarization of microspheres) and the fouling resistance (R(f), induced by the adsorption of BSA inside the membrane pore) must be considered simultaneously for the modeling. These modeling results were in good agreement with the experimental data. These can be applied to the special system considering both R(c) and R(f) as well as the general filtration systems using a stirred cell. (C) 2000 Academic Press.

AB - A study on the variation of the permeate flux was performed in a stirred cell charged with microspheres, to investigate the effects of the stirrer speeds (300, 400, and 600 rpm) and the BSA concentration (0.1, 0.2, 0.4, and 0.8 g/L) under constant pressure. The permeate flux increased over time before the saturation point, but it began to decrease after that point. An increase of the BSA concentration and the stirrer speed resulted in the rapid increase of the permeate flux. This is contrary to the observation of the conventional filtration experiments using a stirred cell. A resistance-in-series model was employed for the modeling of the permeate flux. The cake resistance (R(c), induced by the concentration polarization of microspheres) and the fouling resistance (R(f), induced by the adsorption of BSA inside the membrane pore) must be considered simultaneously for the modeling. These modeling results were in good agreement with the experimental data. These can be applied to the special system considering both R(c) and R(f) as well as the general filtration systems using a stirred cell. (C) 2000 Academic Press.

KW - Flux modeling

KW - Microspheres

KW - Resistance-in-series model

KW - Stirred cell

UR - http://www.scopus.com/inward/record.url?scp=0034664069&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=0034664069&partnerID=8YFLogxK

U2 - 10.1006/jcis.2000.6940

DO - 10.1006/jcis.2000.6940

M3 - Article

AN - SCOPUS:0034664069

VL - 228

SP - 270

EP - 278

JO - Journal of Colloid and Interface Science

JF - Journal of Colloid and Interface Science

SN - 0021-9797

IS - 2

ER -