Multi-modal traffic signal control with priority, signal actuation and coordination

Qing He, Kenneth L Head, Jun Ding

Research output: Contribution to journalArticle

99 Citations (Scopus)

Abstract

Both coordinated-actuated signal control systems and signal priority control systems have been widely deployed for the last few decades. However, these two control systems are often conflicting with each due to different control objectives. This paper aims to address the conflicting issues between actuated-coordination and multi-modal priority control. Enabled by vehicle-to-infrastructure (v2i) communication in Connected Vehicle Systems, priority eligible vehicles, such as emergency vehicles, transit buses, commercial trucks, and pedestrians are able to send request for priority messages to a traffic signal controller when approaching a signalized intersection. It is likely that multiple vehicles and pedestrians will send requests such that there may be multiple active requests at the same time. A request-based mixed-integer linear program (MILP) is formulated that explicitly accommodate multiple priority requests from different modes of vehicles and pedestrians while simultaneously considering coordination and vehicle actuation. Signal coordination is achieved by integrating virtual coordination requests for priority in the formulation. A penalty is added to the objective function when the signal coordination is not fulfilled. This "soft" signal coordination allows the signal plan to adjust itself to serve multiple priority requests that may be from different modes. The priority-optimal signal timing is responsive to real-time actuations of non-priority demand by allowing phases to extend and gap out using traditional vehicle actuation logic. The proposed control method is compared with state-of-practice transit signal priority (TSP) both under the optimized signal timing plans using microscopic traffic simulation. The simulation experiments show that the proposed control model is able to reduce average bus delay, average pedestrian delay, and average passenger car delay, especially for highly congested condition with a high frequency of transit vehicle priority requests.

Original languageEnglish (US)
Pages (from-to)65-82
Number of pages18
JournalTransportation Research Part C: Emerging Technologies
Volume46
DOIs
StatePublished - 2014

Fingerprint

Traffic signals
traffic control
pedestrian
control system
Control systems
Emergency vehicles
traffic
Passenger cars
simulation
Trucks
motor vehicle
penalty
Controllers
Communication
infrastructure

Keywords

  • Connected vehicles
  • Multi-modal traffic control
  • Pedestrian control
  • Signal optimization
  • Traffic signal control
  • Transit priority
  • V2i

ASJC Scopus subject areas

  • Computer Science Applications
  • Management Science and Operations Research
  • Automotive Engineering
  • Transportation

Cite this

Multi-modal traffic signal control with priority, signal actuation and coordination. / He, Qing; Head, Kenneth L; Ding, Jun.

In: Transportation Research Part C: Emerging Technologies, Vol. 46, 2014, p. 65-82.

Research output: Contribution to journalArticle

@article{40d28a83db4f443c92b758bd2e9f79f7,
title = "Multi-modal traffic signal control with priority, signal actuation and coordination",
abstract = "Both coordinated-actuated signal control systems and signal priority control systems have been widely deployed for the last few decades. However, these two control systems are often conflicting with each due to different control objectives. This paper aims to address the conflicting issues between actuated-coordination and multi-modal priority control. Enabled by vehicle-to-infrastructure (v2i) communication in Connected Vehicle Systems, priority eligible vehicles, such as emergency vehicles, transit buses, commercial trucks, and pedestrians are able to send request for priority messages to a traffic signal controller when approaching a signalized intersection. It is likely that multiple vehicles and pedestrians will send requests such that there may be multiple active requests at the same time. A request-based mixed-integer linear program (MILP) is formulated that explicitly accommodate multiple priority requests from different modes of vehicles and pedestrians while simultaneously considering coordination and vehicle actuation. Signal coordination is achieved by integrating virtual coordination requests for priority in the formulation. A penalty is added to the objective function when the signal coordination is not fulfilled. This {"}soft{"} signal coordination allows the signal plan to adjust itself to serve multiple priority requests that may be from different modes. The priority-optimal signal timing is responsive to real-time actuations of non-priority demand by allowing phases to extend and gap out using traditional vehicle actuation logic. The proposed control method is compared with state-of-practice transit signal priority (TSP) both under the optimized signal timing plans using microscopic traffic simulation. The simulation experiments show that the proposed control model is able to reduce average bus delay, average pedestrian delay, and average passenger car delay, especially for highly congested condition with a high frequency of transit vehicle priority requests.",
keywords = "Connected vehicles, Multi-modal traffic control, Pedestrian control, Signal optimization, Traffic signal control, Transit priority, V2i",
author = "Qing He and Head, {Kenneth L} and Jun Ding",
year = "2014",
doi = "10.1016/j.trc.2014.05.001",
language = "English (US)",
volume = "46",
pages = "65--82",
journal = "Transportation Research Part C: Emerging Technologies",
issn = "0968-090X",
publisher = "Elsevier Limited",

}

TY - JOUR

T1 - Multi-modal traffic signal control with priority, signal actuation and coordination

AU - He, Qing

AU - Head, Kenneth L

AU - Ding, Jun

PY - 2014

Y1 - 2014

N2 - Both coordinated-actuated signal control systems and signal priority control systems have been widely deployed for the last few decades. However, these two control systems are often conflicting with each due to different control objectives. This paper aims to address the conflicting issues between actuated-coordination and multi-modal priority control. Enabled by vehicle-to-infrastructure (v2i) communication in Connected Vehicle Systems, priority eligible vehicles, such as emergency vehicles, transit buses, commercial trucks, and pedestrians are able to send request for priority messages to a traffic signal controller when approaching a signalized intersection. It is likely that multiple vehicles and pedestrians will send requests such that there may be multiple active requests at the same time. A request-based mixed-integer linear program (MILP) is formulated that explicitly accommodate multiple priority requests from different modes of vehicles and pedestrians while simultaneously considering coordination and vehicle actuation. Signal coordination is achieved by integrating virtual coordination requests for priority in the formulation. A penalty is added to the objective function when the signal coordination is not fulfilled. This "soft" signal coordination allows the signal plan to adjust itself to serve multiple priority requests that may be from different modes. The priority-optimal signal timing is responsive to real-time actuations of non-priority demand by allowing phases to extend and gap out using traditional vehicle actuation logic. The proposed control method is compared with state-of-practice transit signal priority (TSP) both under the optimized signal timing plans using microscopic traffic simulation. The simulation experiments show that the proposed control model is able to reduce average bus delay, average pedestrian delay, and average passenger car delay, especially for highly congested condition with a high frequency of transit vehicle priority requests.

AB - Both coordinated-actuated signal control systems and signal priority control systems have been widely deployed for the last few decades. However, these two control systems are often conflicting with each due to different control objectives. This paper aims to address the conflicting issues between actuated-coordination and multi-modal priority control. Enabled by vehicle-to-infrastructure (v2i) communication in Connected Vehicle Systems, priority eligible vehicles, such as emergency vehicles, transit buses, commercial trucks, and pedestrians are able to send request for priority messages to a traffic signal controller when approaching a signalized intersection. It is likely that multiple vehicles and pedestrians will send requests such that there may be multiple active requests at the same time. A request-based mixed-integer linear program (MILP) is formulated that explicitly accommodate multiple priority requests from different modes of vehicles and pedestrians while simultaneously considering coordination and vehicle actuation. Signal coordination is achieved by integrating virtual coordination requests for priority in the formulation. A penalty is added to the objective function when the signal coordination is not fulfilled. This "soft" signal coordination allows the signal plan to adjust itself to serve multiple priority requests that may be from different modes. The priority-optimal signal timing is responsive to real-time actuations of non-priority demand by allowing phases to extend and gap out using traditional vehicle actuation logic. The proposed control method is compared with state-of-practice transit signal priority (TSP) both under the optimized signal timing plans using microscopic traffic simulation. The simulation experiments show that the proposed control model is able to reduce average bus delay, average pedestrian delay, and average passenger car delay, especially for highly congested condition with a high frequency of transit vehicle priority requests.

KW - Connected vehicles

KW - Multi-modal traffic control

KW - Pedestrian control

KW - Signal optimization

KW - Traffic signal control

KW - Transit priority

KW - V2i

UR - http://www.scopus.com/inward/record.url?scp=84902006322&partnerID=8YFLogxK

UR - http://www.scopus.com/inward/citedby.url?scp=84902006322&partnerID=8YFLogxK

U2 - 10.1016/j.trc.2014.05.001

DO - 10.1016/j.trc.2014.05.001

M3 - Article

AN - SCOPUS:84902006322

VL - 46

SP - 65

EP - 82

JO - Transportation Research Part C: Emerging Technologies

JF - Transportation Research Part C: Emerging Technologies

SN - 0968-090X

ER -