Nonconservative oscillations of a tool for deep hole honing

A. M. Gouskov, S. A. Voronov, Eric Butcher, S. C. Sinha

Research output: Chapter in Book/Report/Conference proceedingConference contribution

Abstract

The dynamics of rotating tool commonly employed in deep hole honing is considered. Mathematical model of a process including the dynamic model of tool and model of workpiece surface and honing sticks interaction is analyzed. It is shown that interaction forces are nonconservative. Honing tool is modeled as a continuous slender beam with honing mandrel attached at intermediate cross section. Multi-stone tool rotates and has reciprocational motion in axial direction. Honing tones are expanded to the machined surface by special rigid mechanism that provides cutting of workpiece cylindrical surface. The tool vibrates in the transverse and axial directions. The transverse oscillations cause the variation of expansion pressure and change the interaction forces on the surface of the workpiece. Hence the vibrating tool shaft is under act of nonconservative forces depending on its position. The expansion pressure is a critical parameter in honing since its influence on process is different. The removal of stock increase linearly with pressure but the lowest expansion pressure and feed rate possible should be used to increase accuracy. The process productivity can be improved by increasing expansion pressure but may in a certain conditions cause a dynamic instability of tool shaft lateral oscillations. Another method of process productivity increasing is applying additional axial vibration of tool. In this case the tool passes more distance along the machined surface at the same time. But this method requires special machine tool with vibration actuator and additional research of system dynamic stability. Methods of vibratory process rational conditions evaluation are considered. The derived partial differential equations of rotating beam motion are reduced to a set of ordinary differential equations by the Galerkin approximation method. The derived differential equations with time periodic functions are numerically analyzed by Floquet method. The system response is studied for different technology and geometric parameters in non-dimensional form. That makes it possible to analyze a set of real processes applying the similarity conditions.

Original languageEnglish (US)
Title of host publication2003 International Conference Physics and Control, PhysCon 2003 - Proceedings
PublisherInstitute of Electrical and Electronics Engineers Inc.
Pages1074-1083
Number of pages10
Volume4
ISBN (Print)078037939X, 9780780379398
DOIs
StatePublished - 2003
Externally publishedYes
Event1st International Conference Physics and Control, PhysCon 2003 - Saint Petersburg, Russian Federation
Duration: Aug 20 2003Aug 22 2003

Other

Other1st International Conference Physics and Control, PhysCon 2003
CountryRussian Federation
CitySaint Petersburg
Period8/20/038/22/03

Keywords

  • Actuators
  • Differential equations
  • Feeds
  • Machine tools
  • Mathematical model
  • Moment methods
  • Partial differential equations
  • Productivity
  • Shafts
  • Stability

ASJC Scopus subject areas

  • Civil and Structural Engineering
  • Control and Systems Engineering
  • Control and Optimization

Fingerprint Dive into the research topics of 'Nonconservative oscillations of a tool for deep hole honing'. Together they form a unique fingerprint.

  • Cite this

    Gouskov, A. M., Voronov, S. A., Butcher, E., & Sinha, S. C. (2003). Nonconservative oscillations of a tool for deep hole honing. In 2003 International Conference Physics and Control, PhysCon 2003 - Proceedings (Vol. 4, pp. 1074-1083). [1237055] Institute of Electrical and Electronics Engineers Inc.. https://doi.org/10.1109/PHYCON.2003.1237055